Cupcake

I made this card using Complete Cards Vol.2

I started with an A5 card blank. From the kit I printed a pyramage sheet, a decorative paper and a matching insert.

I like to glue the insert into the card before I start to decorate the outside of the card.

I cut a piece of decorative paper to fit the front of the card. I rounded the corners using a paper punch.

I added a white card mat and rounded the corners of it as well 

I rounded the corners of the first layer of pyramage and glued it in place.

For the next layer of the pyramagre i added 3D glue before adding it to the card.you can use foam pads if you wish but I prefer glue because if you dont match up the layers properly you can wiggle it about before the glue dries.

Continue adding the layers in this way working from the largest to the smallest piece to give your finished card.